thermal contact resistance

A new model of thermal contact resistance based on the statistic characteristic of roughness profile is proposed in this paper.

本文在对粗糙度曲线统计特征分析的基础上，提出了一种接触热阻的计算模型。

Thermal Contact Resistance and Thermal Conductive Filler

接触热阻与接触导热填料

The interface thermal contact resistance between an impinging molten droplet and cold substrate plays an important role in the droplet solidification.

基体和熔融液滴之间的界面接触热阻是影响液滴凝固过程的一个主要因素。

Concept of Thermal Contact Resistance and Influences of Hysteresis and Tangential Stress

接触热阻的概念、滞后效应以及切应力的影响

Thermal Contact Resistance in Mechanical Structures

机械结构中的接触热阻

Experimental research on the thermal contact resistance between Cu-Cu in vacuum and low temperature

低温真空下Cu-Cu界面间接触热阻的实验研究

The existence of the contact resistance must be considered when accurate thermal conductivity measurements are performed.

如果要精确地测量热导率,就必需考虑接触阻力的存在问题.

The mechanism of thermal contact resistance is discussed in detail, and influences of hysteresis and tangential stress on this resistance are studied experimentally and theoretically.

本文对产生接触热阻的机理进行了深入的讨论，对影响接触热阻的滞后效应和接触面上切应力等因素进行了实验研究和理论探讨。

A prediction of thermal contact resistance

一种接触热阻的预测方法

On the basis investigation of thermal contact resistance developed in the world, the development on thermal contact resistance and thermal conductive filler is briefly introduced.

在调研国内外接触热阻研究的基础上，介绍了关于接触热阻及接触导热填料的研究发展情况。

According to the experiment results, the formula used to calculate the thermal contact resistance was adjusted.

根据实验结果，对接触热阻的计算公式进行了修正。

Experiment Research for the Interfacial Thermal Contact Resistance

界面接触热阻影响因素的实验研究

This paper studied the influence of the different conductor material such as AU| Pd-Au, the different film thickness. 125 ℃. 300 ℃ thermal aging and temperature cycle on bond strength with two methods of destructive wire bond pull test and bond contact resistance test.

本文使用焊点破坏性拉力试验和焊点的接触电阻测试两种方法，研究了导体材料（Au、Pd&Au）、膜层厚度、125℃、300℃热老练和温度循环对焊点键合强度的影响。

The experimental principles and equipment of thermal contact resistance were introduced.

介绍了接触热阻的测量原理和传统的实验装置。

Theoretical prediction and experimental investigation of finned tubes thermal contact resistance

翅片管接触热阻的理论预测和试验研究

The application of thermal contact resistance in the mechanical engineering and the design of machine tools is discussed.

论述了接触热阻在机械工程和机床研究中的应用；

An analytic thermal contact resistance model based on classical heat conduction theory and the advanced M-B fractal model is developed under some hypotheses.

结合分形接触理论和经典热传递理论，在W-M函数的改进M-B分形接触模型的基础上，建立了一定假设条件下的结合面接触热阻模型，并推导出具有尺度独立性的接触热阻理论解析公式。

Measurement of the thermal contact resistance between two-layer complex mediums

测定双层组合介质接触热阻

Many theoretical and steady experimental studies were developed, and researchers consistently agreed that the constriction of heat flow at the rough contact surface causes thermal contact resistance.

国内外学者对此开展了大量的理论分析工作和建立在稳态热流法基础上的实验研究，并一致认为界面接触热阻产生的主要原因是微观粗糙接触界面处发生的热流收缩。

Experiment on Thermal Contact Resistance TESTING

接触热阻的试验研究

The effect of contact interfaces on thermal contact resistance at low temperature and vacuum

真空低温下接触表面对接触热阻的影响

The influence of the dose of graphite and the content of alcohol on thermal contact resistance ( TCR) was studied.

从理论上分析了隔离剂对接触热导的影响，并通过实验研究了接触热导随喷涂量和表面活性剂乙醇添加量的变化规律。

Fractal Description of Thermal Contact Resistance between Rough Surfaces

粗糙表面接触热阻的分形描述

In this paper, the temperature difference induced by thermal contact resistance between two semi-infinite long cylinders at low temperature and vacuum has been studied theoretically, in the meantime, some useful calculation expressions are presented.

针对低温真空条件下，半无限长圆柱间的接触热阻温差进行了理论分析，并得到了一些有用的近似计算公式；

Effect of thermal contact resistance on the cook-off time of solid rocket motor

接触热阻对固体火箭发动机烤燃时间的影响

Measurement of Electrical and Thermal Contact Resistance of Thermoelectric Device

温差电器件接触电阻和接触热阻的测试及分析

Heat transfer within the substrate is by conduction alone. Thermal contact resistance at the droplet-substrate interface is included in the model.

数值模拟中对基体内部只考虑热传导作用，并且引入了液滴-基体界面处的接触热阻这一参数。

Theoretical Analysis of Thermal Contact Resistance Between Solid Interfaces

固体界面间接触热阻的理论分析

Using double heat flux meter method to measure the thermal contact resistance of solid material at low temperature and vacuum

双热流法测定低温真空下固体界面的接触热阻

When the power of electronics is small, the thermal contact resistance can be ignored.

当电子元件功率较小时，接触热阻对散热不会产生特别明显的影响。